# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/media/i2c/nxp,tda19971.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: NXP TDA1997x HDMI receiver

maintainers:
  - Frank Li <Frank.Li@nxp.com>

description: |
  The TDA19971/73 are HDMI video receivers.

  The TDA19971 Video port output pins can be used as follows:
   - RGB 8bit per color (24 bits total): R[11:4] B[11:4] G[11:4]
   - YUV444 8bit per color (24 bits total): Y[11:4] Cr[11:4] Cb[11:4]
   - YUV422 semi-planar 8bit per component (16 bits total): Y[11:4] CbCr[11:4]
   - YUV422 semi-planar 10bit per component (20 bits total): Y[11:2] CbCr[11:2]
   - YUV422 semi-planar 12bit per component (24 bits total): - Y[11:0] CbCr[11:0]
   - YUV422 BT656 8bit per component (8 bits total): YCbCr[11:4] (2-cycles)
   - YUV422 BT656 10bit per component (10 bits total): YCbCr[11:2] (2-cycles)
   - YUV422 BT656 12bit per component (12 bits total): YCbCr[11:0] (2-cycles)

  The TDA19973 Video port output pins can be used as follows:
   - RGB 12bit per color (36 bits total): R[11:0] B[11:0] G[11:0]
   - YUV444 12bit per color (36 bits total): Y[11:0] Cb[11:0] Cr[11:0]
   - YUV422 semi-planar 12bit per component (24 bits total): Y[11:0] CbCr[11:0]
   - YUV422 BT656 12bit per component (12 bits total): YCbCr[11:0] (2-cycles)

  The Video port output pins are mapped via 4-bit 'pin groups' allowing
  for a variety of connection possibilities including swapping pin order within
  pin groups. The video_portcfg device-tree property consists of register mapping
  pairs which map a chip-specific VP output register to a 4-bit pin group. If
  the pin group needs to be bit-swapped you can use the *_S pin-group defines.

properties:
  compatible:
    enum:
      - nxp,tda19971
      - nxp,tda19973

  reg:
    maxItems: 1

  interrupts:
    maxItems: 1

  DOVDD-supply: true

  DVDD-supply: true

  AVDD-supply: true

  '#sound-dai-cells':
    const: 0

  port:
    $ref: /schemas/graph.yaml#/$defs/port-base
    unevaluatedProperties: false

    properties:
      endpoint:
        $ref: /schemas/media/video-interfaces.yaml#
        unevaluatedProperties: false

  nxp,vidout-portcfg:
    $ref: /schemas/types.yaml#/definitions/uint32-matrix
    minItems: 1
    maxItems: 4
    items:
      items:
        - description: Video Port control registers index.
          maximum: 8
          minimum: 0
        - description: pin(pinswapped) groups

    description:
      array of pairs mapping VP output pins to pin groups.

  nxp,audout-format:
    enum:
      - i2s
      - spdif

  nxp,audout-width:
    $ref: /schemas/types.yaml#/definitions/uint32
    enum: [8, 16, 24, 32]
    description:
      width of audio output data bus.

  nxp,audout-layout:
    $ref: /schemas/types.yaml#/definitions/uint32
    enum: [0, 1]
    description:
      data layout (0=AP0 used, 1=AP0/AP1/AP2/AP3 used).

  nxp,audout-mclk-fs:
    $ref: /schemas/types.yaml#/definitions/uint32
    description:
      Multiplication factor between stream rate and codec mclk.

required:
  - compatible
  - reg
  - interrupts
  - DOVDD-supply
  - AVDD-supply
  - DVDD-supply

additionalProperties: false

examples:
  - |
    #include <dt-bindings/interrupt-controller/irq.h>
    #include <dt-bindings/media/tda1997x.h>

    i2c {
        #address-cells = <1>;
        #size-cells = <0>;

        hdmi-receiver@48 {
            compatible = "nxp,tda19971";
            reg = <0x48>;
            pinctrl-names = "default";
            pinctrl-0 = <&pinctrl_tda1997x>;
            interrupt-parent = <&gpio1>;
            interrupts = <7 IRQ_TYPE_LEVEL_LOW>;
            DOVDD-supply = <&reg_3p3v>;
            AVDD-supply = <&reg_1p8v>;
            DVDD-supply = <&reg_1p8v>;
            /* audio */
            #sound-dai-cells = <0>;
            nxp,audout-format = "i2s";
            nxp,audout-layout = <0>;
            nxp,audout-width = <16>;
            nxp,audout-mclk-fs = <128>;
            /*
             * The 8bpp YUV422 semi-planar mode outputs CbCr[11:4]
             * and Y[11:4] across 16bits in the same pixclk cycle.
             */
            nxp,vidout-portcfg =
                /* Y[11:8]<->VP[15:12]<->CSI_DATA[19:16] */
                < TDA1997X_VP24_V15_12 TDA1997X_G_Y_11_8 >,
                /* Y[7:4]<->VP[11:08]<->CSI_DATA[15:12] */
                < TDA1997X_VP24_V11_08 TDA1997X_G_Y_7_4 >,
                /* CbCc[11:8]<->VP[07:04]<->CSI_DATA[11:8] */
                < TDA1997X_VP24_V07_04 TDA1997X_R_CR_CBCR_11_8 >,
                /* CbCr[7:4]<->VP[03:00]<->CSI_DATA[7:4] */
                < TDA1997X_VP24_V03_00 TDA1997X_R_CR_CBCR_7_4 >;

            port {
                endpoint {
                    remote-endpoint = <&ipu1_csi0_mux_from_parallel_sensor>;
                    bus-width = <16>;
                    hsync-active = <1>;
                    vsync-active = <1>;
                    data-active = <1>;
                };
            };
        };
    };