Osmocom E1 recorder =================== (C) 2016 by Harald Welte The idea of this program is to be able to build a "poor mans E1/T1 recorder" purposes of data analysis, *without* any special equipment. This approach is more risky than a purely passive, hardware based approach as that of the Osmocom e1-tracer released at https://osmocom.org/projects/e1-t1-adapter/wiki/E1_tracer If you can, it is strongly recommended to use the purely passive, high-impedance tap approach of e1-tracer and not the poor-man's software proxy approach presented in osmo-e1-recorder. Setup ----- To do so, two E1 cards are used as some kind of proxy for the E1 communication. Recording of a single E1 link always requires two E1 interface cards, one for each direction. Recording can be performed either * passively, using a E1 Tap adapter * as a proxy / man-in-the-middle All timeslots will be opened in "raw" mode, making sure the recording will work whether or not there is HDLC-based signalling (MTP or LAPD), PCM voice, TRAU frames or anything else on the line. Recording will be done on a per-timeslot basis, dumping the raw bytes read for this timeslot into a file. New files are started regularly, after reaching a pre-determined file size limit. File names contain RTC time stamping and timeslot number. Later possible extensions could include automatic detection of the payload and a more intelligent storage format (e.g. in case of HDLC based signalling).