! osmo-bsc default configuration ! (assumes STP to run on 127.0.0.1 and uses default point codes) ! log stderr logging color 1 logging print category-hex 0 logging print category 1 logging timestamp 0 logging print file basename last logging print level 1 e1_input e1_line 0 driver ipa network network country code 1 mobile network code 1 encryption a5 0 neci 1 paging any use tch 0 handover 0 handover algorithm 1 handover1 window rxlev averaging 10 handover1 window rxqual averaging 1 handover1 window rxlev neighbor averaging 10 handover1 power budget interval 6 handover1 power budget hysteresis 3 handover1 maximum distance 9999 ! T3212 is in units of 6min, so below we set 5 * 6 = 30min timer net T3212 5 mgw 0 remote-ip 127.0.0.1 remote-port 2427 local-port 2727 bts 0 type osmo-bts band DCS1800 cell_identity 6969 location_area_code 0x0001 base_station_id_code 63 ms max power 15 cell reselection hysteresis 4 rxlev access min 0 radio-link-timeout 32 channel allocator mode set-all ascending rach tx integer 9 rach max transmission 7 channel-description attach 1 channel-description bs-pa-mfrms 5 channel-description bs-ag-blks-res 1 early-classmark-sending forbidden ipa unit-id 6969 0 oml ipa stream-id 255 line 0 codec-support fr gprs mode none trx 0 rf_locked 0 arfcn 871 nominal power 23 ! to use full TRX power, set max_power_red 0 max_power_red 20 rsl e1 tei 0 timeslot 0 phys_chan_config CCCH+SDCCH4 hopping enabled 0 timeslot 1 phys_chan_config TCH/F hopping enabled 0 timeslot 2 phys_chan_config TCH/F hopping enabled 0 timeslot 3 phys_chan_config TCH/F hopping enabled 0 timeslot 4 phys_chan_config TCH/F hopping enabled 0 timeslot 5 phys_chan_config TCH/F hopping enabled 0 timeslot 6 phys_chan_config TCH/F hopping enabled 0 timeslot 7 phys_chan_config TCH/F hopping enabled 0 msc 0 ! Do not allow emergency calls unless you can route ! them to the local emergency services allow-emergency deny bsc mid-call-timeout 0