# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/spi/st,stm32mp25-ospi.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: STMicroelectronics STM32 Octal Serial Peripheral Interface (OSPI)

maintainers:
  - Patrice Chotard <patrice.chotard@foss.st.com>

allOf:
  - $ref: spi-controller.yaml#

properties:
  compatible:
    const: st,stm32mp25-ospi

  reg:
    maxItems: 1

  memory-region:
    description:
      Memory region to be used for memory-map read access.
      In memory-mapped mode, read access are performed from the memory
      device using the direct mapping.
    maxItems: 1

  clocks:
    maxItems: 1

  interrupts:
    maxItems: 1

  resets:
    items:
      - description: phandle to OSPI block reset
      - description: phandle to delay block reset

  dmas:
    maxItems: 2

  dma-names:
    items:
      - const: tx
      - const: rx

  st,syscfg-dlyb:
    description: configure OCTOSPI delay block.
    $ref: /schemas/types.yaml#/definitions/phandle-array
    items:
      - description: phandle to syscfg
      - description: register offset within syscfg

  access-controllers:
    description: phandle to the rifsc device to check access right
      and in some cases, an additional phandle to the rcc device for
      secure clock control.
    items:
      - description: phandle to bus controller
      - description: phandle to clock controller
    minItems: 1

  power-domains:
    maxItems: 1

required:
  - compatible
  - reg
  - clocks
  - interrupts
  - st,syscfg-dlyb

unevaluatedProperties: false

examples:
  - |
    #include <dt-bindings/clock/st,stm32mp25-rcc.h>
    #include <dt-bindings/interrupt-controller/arm-gic.h>
    #include <dt-bindings/reset/st,stm32mp25-rcc.h>

    spi@40430000 {
      compatible = "st,stm32mp25-ospi";
      reg = <0x40430000 0x400>;
      memory-region = <&mm_ospi1>;
      interrupts = <GIC_SPI 163 IRQ_TYPE_LEVEL_HIGH>;
      dmas = <&hpdma 2 0x62 0x00003121 0x0>,
             <&hpdma 2 0x42 0x00003112 0x0>;
      dma-names = "tx", "rx";
      clocks = <&scmi_clk CK_SCMI_OSPI1>;
      resets = <&scmi_reset RST_SCMI_OSPI1>, <&scmi_reset RST_SCMI_OSPI1DLL>;
      access-controllers = <&rifsc 74>;
      power-domains = <&CLUSTER_PD>;
      st,syscfg-dlyb = <&syscfg 0x1000>;

      #address-cells = <1>;
      #size-cells = <0>;

      flash@0 {
        compatible = "jedec,spi-nor";
        reg = <0>;
        spi-rx-bus-width = <4>;
        spi-max-frequency = <108000000>;
      };
    };