// SPDX-License-Identifier: BSD-3-Clause /* * Copyright (c) 2023, Dang Huynh */ #include #include #include / { thermal-zones { pm8937-thermal { polling-delay-passive = <0>; polling-delay = <0>; thermal-sensors = <&pm8937_temp>; trips { trip0 { temperature = <105000>; hysteresis = <0>; type = "passive"; }; trip1 { temperature = <125000>; hysteresis = <0>; type = "hot"; }; trip2 { temperature = <145000>; hysteresis = <0>; type = "critical"; }; }; }; }; }; &spmi_bus { pmic@0 { compatible = "qcom,pm8937", "qcom,spmi-pmic"; reg = <0x0 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; pon@800 { compatible = "qcom,pm8916-pon"; reg = <0x800>; mode-bootloader = <0x2>; mode-recovery = <0x1>; pm8937_pwrkey: pwrkey { compatible = "qcom,pm8941-pwrkey"; interrupts = <0 0x8 0 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; linux,code = ; }; pm8937_resin: resin { compatible = "qcom,pm8941-resin"; interrupts = <0 0x8 1 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; status = "disabled"; }; }; pm8937_gpios: gpio@c000 { compatible = "qcom,pm8937-gpio", "qcom,spmi-gpio"; reg = <0xc000>; gpio-controller; gpio-ranges = <&pm8937_gpios 0 0 8>; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; }; pm8937_mpps: mpps@a000 { compatible = "qcom,pm8937-mpp", "qcom,spmi-mpp"; reg = <0xa000>; gpio-controller; gpio-ranges = <&pm8937_mpps 0 0 4>; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; }; pm8937_temp: temp-alarm@2400 { compatible = "qcom,spmi-temp-alarm"; reg = <0x2400>; interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>; io-channels = <&pm8937_vadc VADC_DIE_TEMP>; io-channel-names = "thermal"; #thermal-sensor-cells = <0>; }; pm8937_vadc: adc@3100 { compatible = "qcom,spmi-vadc"; reg = <0x3100>; interrupts = <0 0x31 0 IRQ_TYPE_EDGE_RISING>; #address-cells = <1>; #size-cells = <0>; #io-channel-cells = <1>; channel@8 { reg = ; }; channel@9 { reg = ; }; channel@a { reg = ; }; channel@c { reg = ; }; channel@e { reg = ; }; channel@f { reg = ; }; }; rtc@6000 { compatible = "qcom,pm8941-rtc"; reg = <0x6000>, <0x6100>; reg-names = "rtc", "alarm"; interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; }; }; pmic@1 { compatible = "qcom,pm8937", "qcom,spmi-pmic"; reg = <0x1 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; pm8937_spmi_regulators: regulators { compatible = "qcom,pm8937-regulators"; }; }; };