// SPDX-License-Identifier: GPL-2.0 #include #include #include #include "qcom-apq8064-v2.0.dtsi" #include "pm8821.dtsi" #include "pm8921.dtsi" / { model = "Asus Nexus7(flo)"; compatible = "asus,nexus7-flo", "qcom,apq8064"; chassis-type = "tablet"; aliases { serial0 = &gsbi7_serial; serial1 = &gsbi6_serial; }; chosen { stdout-path = "serial0:115200n8"; }; reserved-memory { #address-cells = <1>; #size-cells = <1>; ranges; ramoops@88d00000 { compatible = "ramoops"; reg = <0x88d00000 0x100000>; record-size = <0x00020000>; console-size = <0x00020000>; ftrace-size = <0x00020000>; }; }; ext_3p3v: regulator-ext-3p3v { compatible = "regulator-fixed"; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; regulator-name = "ext_3p3v"; startup-delay-us = <0>; gpio = <&tlmm_pinmux 77 GPIO_ACTIVE_HIGH>; enable-active-high; regulator-boot-on; }; gpio-keys { compatible = "gpio-keys"; key-volume-up { label = "Volume Up"; gpios = <&pm8921_gpio 4 GPIO_ACTIVE_HIGH>; linux,code = ; }; key-volume-down { label = "Volume Down"; gpios = <&pm8921_gpio 38 GPIO_ACTIVE_HIGH>; linux,code = ; }; }; soc { sram@2a03f000 { compatible = "qcom,apq8064-imem", "syscon", "simple-mfd"; reg = <0x2a03f000 0x1000>; reboot-mode { compatible = "syscon-reboot-mode"; offset = <0x65c>; mode-normal = <0x77665501>; mode-bootloader = <0x77665500>; mode-recovery = <0x77665502>; }; }; }; }; &dsi0 { vdda-supply = <&pm8921_l2>;/*VDD_MIPI1 to 4*/ vdd-supply = <&pm8921_l8>; vddio-supply = <&pm8921_lvs7>; avdd-supply = <&pm8921_l11>; status = "okay"; panel@0 { reg = <0>; compatible = "jdi,lt070me05000"; vddp-supply = <&pm8921_l17>; iovcc-supply = <&pm8921_lvs7>; enable-gpios = <&pm8921_gpio 36 GPIO_ACTIVE_HIGH>; reset-gpios = <&tlmm_pinmux 54 GPIO_ACTIVE_LOW>; dcdc-en-gpios = <&pm8921_gpio 23 GPIO_ACTIVE_HIGH>; port { panel_in: endpoint { remote-endpoint = <&dsi0_out>; }; }; }; }; &dsi0_in { remote-endpoint = <&mdp_dsi1_out>; }; &dsi0_out { remote-endpoint = <&panel_in>; data-lanes = <0 1 2 3>; }; &dsi0_phy { vddio-supply = <&pm8921_lvs7>;/*VDD_PLL2_1 to 7*/ status = "okay"; }; &gsbi1 { qcom,mode = ; status = "okay"; }; &gsbi1_i2c { status = "okay"; clock-frequency = <200000>; eeprom@52 { compatible = "atmel,24c128"; reg = <0x52>; pagesize = <32>; }; bq27541@55 { compatible = "ti,bq27541"; reg = <0x55>; }; }; &gsbi3 { qcom,mode = ; status = "okay"; }; &gsbi3_i2c { clock-frequency = <200000>; status = "okay"; trackpad@10 { compatible = "elan,ekth3500"; reg = <0x10>; interrupt-parent = <&tlmm_pinmux>; interrupts = <6 IRQ_TYPE_EDGE_FALLING>; }; }; &gsbi6 { qcom,mode = ; status = "okay"; }; &gsbi6_serial { pinctrl-names = "default"; pinctrl-0 = <&gsbi6_uart_4pins>; status = "okay"; }; &gsbi7 { qcom,mode = ; status = "okay"; }; &gsbi7_serial { status = "okay"; }; &mdp { status = "okay"; }; &mdp_dsi1_out { remote-endpoint = <&dsi0_in>; }; &pm8821 { interrupts-extended = <&tlmm_pinmux 76 IRQ_TYPE_LEVEL_LOW>; }; &pm8921 { interrupts-extended = <&tlmm_pinmux 74 IRQ_TYPE_LEVEL_LOW>; }; &rpm { regulators { compatible = "qcom,rpm-pm8921-regulators"; vdd_l1_l2_l12_l18-supply = <&pm8921_s4>; vin_lvs1_3_6-supply = <&pm8921_s4>; vin_lvs4_5_7-supply = <&pm8921_s4>; vdd_l24-supply = <&pm8921_s1>; vdd_l25-supply = <&pm8921_s1>; vin_lvs2-supply = <&pm8921_s1>; vdd_l26-supply = <&pm8921_s7>; vdd_l27-supply = <&pm8921_s7>; vdd_l28-supply = <&pm8921_s7>; vdd_ncp-supply = <&pm8921_l6>; /* Buck SMPS */ pm8921_s1: s1 { regulator-always-on; regulator-min-microvolt = <1225000>; regulator-max-microvolt = <1225000>; qcom,switch-mode-frequency = <3200000>; bias-pull-down; }; /* msm otg HSUSB_VDDCX */ pm8921_s3: s3 { regulator-min-microvolt = <500000>; regulator-max-microvolt = <1150000>; qcom,switch-mode-frequency = <4800000>; }; /* * msm_sdcc.1-sdc-vdd_io * tabla2x-slim-CDC_VDDA_RX * tabla2x-slim-CDC_VDDA_TX * tabla2x-slim-CDC_VDD_CP * tabla2x-slim-VDDIO_CDC */ pm8921_s4: s4 { regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; qcom,switch-mode-frequency = <3200000>; regulator-always-on; }; pm8921_s7: s7 { regulator-min-microvolt = <1300000>; regulator-max-microvolt = <1300000>; qcom,switch-mode-frequency = <3200000>; }; /* mipi_dsi.1-dsi1_pll_vdda */ pm8921_l2: l2 { regulator-min-microvolt = <1200000>; regulator-max-microvolt = <1200000>; regulator-always-on; }; /* msm_otg-HSUSB_3p3 */ pm8921_l3: l3 { regulator-min-microvolt = <3075000>; regulator-max-microvolt = <3075000>; bias-pull-down; }; /* msm_otg-HSUSB_1p8 */ pm8921_l4: l4 { regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; bias-pull-down; }; /* msm_sdcc.1-sdc_vdd */ pm8921_l5: l5 { regulator-min-microvolt = <2950000>; regulator-max-microvolt = <2950000>; regulator-always-on; bias-pull-down; }; pm8921_l6: l6 { regulator-min-microvolt = <2950000>; regulator-max-microvolt = <2950000>; }; pm8921_l8: l8 { }; /* mipi_dsi.1-dsi1_avdd */ pm8921_l11: l11 { regulator-min-microvolt = <3000000>; regulator-max-microvolt = <3000000>; bias-pull-down; regulator-always-on; }; /* pwm_power for backlight */ pm8921_l17: l17 { regulator-min-microvolt = <3000000>; regulator-max-microvolt = <3000000>; regulator-always-on; }; /* camera, qdsp6 */ pm8921_l23: l23 { regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; bias-pull-down; }; /* * tabla2x-slim-CDC_VDDA_A_1P2V * tabla2x-slim-VDDD_CDC_D */ pm8921_l25: l25 { regulator-min-microvolt = <1250000>; regulator-max-microvolt = <1250000>; bias-pull-down; }; pm8921_lvs1: lvs1 { bias-pull-down; }; pm8921_lvs4: lvs4 { bias-pull-down; }; pm8921_lvs5: lvs5 { bias-pull-down; }; pm8921_lvs6: lvs6 { bias-pull-down; }; /* * mipi_dsi.1-dsi1_vddio * pil_riva-pll_vdd */ pm8921_lvs7: lvs7 { bias-pull-down; }; }; }; /* eMMC */ &sdcc1 { vmmc-supply = <&pm8921_l5>; vqmmc-supply = <&pm8921_s4>; status = "okay"; }; &usb_hs1_phy { v3p3-supply = <&pm8921_l3>; v1p8-supply = <&pm8921_l4>; }; /* OTG */ &usb1 { dr_mode = "otg"; status = "okay"; };